Lorenzetti Instant Shower Installation in Nairobi.

Installing an electric instant shower in Nairobi, Kenya requires careful preparation and adherence to safety guidelines. Below are the steps to follow:

1. Gather the Necessary Tools and Materials

• Instant shower unit (e.g., Lorenzetti model)
• Screwdriver (flathead and Phillips)
• Drill and drill bits
• Adjustable wrench
• Rawl plugs and screws
• PVC or CPVC pipe and fittings for plumbing
• Teflon tape
• Electrical wire (at least 2.5mm², depending on power requirements)
• Circuit breaker (30A-40A) for safety
• Multimeter (to test voltage)

2. Switch Off the Main Power Supply

• Before beginning any work, turn off the main power supply at the circuit breaker. This ensures safety by preventing any accidental electric shock during installation.

3. Prepare the Water Line

• Ensure that a water line is available near the installation location. The line should be a direct supply, ideally with sufficient pressure.
• Use PVC or CPVC pipes that can handle hot water. Install a stop valve (control valve) on the water supply to control water flow to the instant shower.

4. Mark and Drill Mounting Holes

• Place the shower unit against the wall where you plan to install it.
• Mark the points for drilling based on the mounting holes of the shower unit.
• Drill holes using an appropriate drill bit, and insert rawl plugs into the holes.

5. Mount the Shower Unit

• Attach the instant shower unit to the wall using screws and a screwdriver. Ensure that the unit is firmly secured, as it will need to support its weight during use.

6. Connect the Water Supply

• Use Teflon tape to wrap around the shower inlet fitting to ensure a watertight connection.
• Connect the water pipe to the shower inlet and tighten it securely with an adjustable wrench. Ensure there are no leaks by turning on the water to test the connection.

7. Electrical Connections

• Use electrical wiring of at least 2.5mm² to connect the shower unit to the power supply.
• Install a circuit breaker (30A-40A) to protect the unit. The circuit breaker should be placed near the distribution board.
• Run the wiring from the circuit breaker to the shower unit, ensuring that the wires are adequately insulated. Secure the wires in the terminals as indicated on the unit (usually live, neutral, and earth).
• Connect the earth wire properly to ensure user safety.

8. Test the Electrical Installation

• Before switching on the power, use a multimeter to check for proper connections.
• Turn on the water and ensure that the flow rate is sufficient. The water pressure should meet the shower’s requirements.
• Switch on the power at the circuit breaker and test the shower unit by turning the shower on. Make sure the water heats up properly during Lorenzetti Instant Shower Installation.

9. Test and Adjust Temperature

• Set the shower unit to your desired temperature setting and test the water temperature.
• Ensure that the safety features, such as temperature adjustment, work as intended.

10. Safety Checks and Final Adjustments

• Verify that there are no water leaks at the connection points.
• Ensure the electrical wiring is not exposed and is safely secured.
• Make sure the power is properly grounded to prevent electrical hazards.

Safety Tips

• Always hire a qualified electrician if you are unsure about any electrical connections.
• Use a dedicated circuit for the instant shower to prevent overloading.
• Avoid operating the shower if there are any electrical faults or water leaks.
• Regularly check for any wear and tear on both the plumbing and electrical components.

Proper installation of an electric instant shower is crucial for safety and efficiency. Ensuring that the plumbing and electrical connections are secure will allow you to enjoy a consistent supply of hot water without worries.